SJY LiFePO4 24V 100AH Description:

The following is the description of SJY LiFePO4 48V 100AH from datasheet. You can also check out data sheet.

Battery Type: Lifepo4 battery pack 
Voltage: 12.8V/25.6V
Battery Capacity: 100Ah/200Ah
Span Life: 4000+ cycles or more 
Operating Temperature: -20~60°C 
Charger: 14.6V/29.2V 10A LFP Charger

Scope:

Scope is very for understanding SJY LiFePO4 48V 100AH .This product is designed and manufactured by Shenzhen Saijiaoyang Energy Technology Co., LTD. LFP battery pack (including BMS). It consists of 16S1P units in series. Battery assembly intelligent sorting, accurate and reliable. BMS uses a professional protection board test system, which is fully tested before going onlinetoensurethat the battery pack is fully and effectively protected by BMS during use. This product has the characteristics of high energy density, long life, safety and reliability, light weight, wide temperature range, etc.

2.Battery Specification :

SJY LiFePO4 48V 100AH

SJY LiFePO4 48V 100AH

BMS Basic protection function BMS:

Overcharge protection is very important in SJY LiFePO4 48V 100AH When the battery is charged, the voltage continues to rise, underproduction board detects that the voltage of any cell is higher than that of the battery Charge protection value, the protection board starts timing immediately, when the time reaches the overcharge protection delay, the protection board turns off the charging MOSTube, charge cut-off, can not charge at this time.

Overcharge protection recovery: After the overvoltage protection occurs on theprotectionboard,the battery voltage drops when the battery is standing or discharging When the protection board detects that the voltage of each section is lower than the overcharge protection recovery voltage,the protection board outputs the signal and starts the charging MOS tube.It canbechargedatthis point.

Over Discharge protection: When the battery is in the discharge state, the voltagecontinuestodecrease, and the protection board detects that the voltage of any cell is lower than overdischarge protection
Protection value, the protection board starts timing immediately, when the timereachestheover-discharge protection delay, the output signal of the protection b48V 100A Plasticoard turns off the discharge MOS Tube, discharge cutoff, load lock circuit work, can not discharge at this time.